For Direct Joining (DWP)Due to their special acelerational design of the pipe, the Venturi Nozzles the speed of the abrasive stream on the exit is two times higher then those with a streight pipe. The usage of air and abrasive is just a little bit higher.
According to the scheme the shape of Venturi is consisted of three areas – an ingoing cone, a short straight area, and a following outgoing cone. The diameter of the straignt area is defining the nominal diameter of the pipe.
Venturi Nozzles DWP Type
Section: Straight Cone
Alluminium Casing
Direct connection to the pipe with an inner diameter of 25 mm (1")
| DWP 6/25 | 6 mm | 25 mm | 100 mm |
| DWP 8/25 | 8 mm | 25 mm | 100 mm |
| DWP 10/25 | 10 mm | 25 mm | 100 mm |
| DWP 10/25A | 10 mm | 25 mm | 110 mm |
Venturi Nozzles DWP Type
Section: Straight Cone, Lenght 110 mm
Alluminium Casing
Direct connection to the pipe with an inner diameter of 32 mm (1-1/4")
| DWP 6/32 | 6 mm | 32 mm | 110 mm |
| DWP 8/32 | 8 mm | 32 mm | 110 mm |
| DWP 10/32 | 10 mm | 32 mm | 110 mm |
| DWP 12/32 | 12 mm | 32 mm | 110 mm |
Venturi Nozzles DWP Type
Section: Straight Cone, Lenght 165 mm
Alluminium Casing
Direct connection to the pipe with an inner diameter of 32 mm (1-1/4")
| DWP 8/32A | 8 mm | 32 mm | 165 mm |
| DWP 10/32A | 10 mm | 32 mm | 165 mm |
| DWP 12/32A | 12 mm | 32 mm | 165 mm |
| 
